Re: What does everybody use...

No I dont think so as the most recent Artisan and Pro SW use AHHA's own interface boards BUT early SW (ver3 etc 1994) would run off the
parallel port.
Brian.

John Stevenson wrote:

> From: john@... (John Stevenson)
>
> On Wed, 19 May 1999 16:12:45 -0400, you wrote:
>
> >From: Brian Fairey <bfairey@...>
> >
> >Ward, I also use AHHA gear and also plan to do a lathe using a Dan Mauch driver board and the AHHA software(very early style using
> >the parallel port)
> >Brian, Ont, Canada.
>
> Brian,
> Any chance on some more details of using the Ahha software with Dan's boards??
> I also run Ahha and would be interested in going this way for a small
> positioning table.
> Can you use the later software for Artisan. I have version 3.2
>
> >Ward Merkouris wrote:
> >
> >> From: Ward Merkouris <ward@...>
> >>
> >> Hi Jon,
> >>
> >> I'm new to the list, this is the first message received. As I have missed the previous messages, I'm wondering if the extra
> >> boards you have made are for stepper motors or DC motors with encoders.
> >>
> >> I currently have an AHHA setup (4 axis) on a small bed mill but am interested in obtaining another set of motor drivers and
> >> motors for use on a small lathe. The AHHA software and board issues step and direction signals oa TTL level. Would your boards
> >> be compatible with this?
> >>
>
> Regards,
> John Stevenson
> Nottingham, England
>
> ------------------------------------------------------------------------
> It's finally here! What's your opinion?
> http://www.onelist.com
> Create a Star Wars discussion group at ONElist.
> ------------------------------------------------------------------------
> welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the discussion of shop built systems in the above catagories.