Re: ACE Converter anomaly, REDWOOD

--- In CAD_CAM_EDM_DRO@y..., Alan Marconett KM6VV <KM6VV@a...> wrote:

> Hi Milton,
>
> I'd love to see pix of the router table you built with the "motion
> control kit". I have an extra one, and I think that's what I'm

going to

> do with it!
> Also, I'm curious about cutting wood. This weekend, my youngest son

set

> out to cut redwood with my new RF-31 mill. New two-flue 3/8

endmill.

> .20" cuts, it went fine, "normal milling", until he got to the end

of

> the board. He was making a 1/2" x 7/16" lap joint, and the "end"

grain

> of the board splintered when the cutter began to leave the stock.

Any

> suggestions?

Alan
Redwood is famous for tearng or splintering under those
conditions,I would try a 4 flute cutter[3000rpm?] and climb cut
the piece, on my table I would have my router at 12-15000 for
a four flute and full on at 24000 for a two flute.

Carl