Re: [CAD_CAM_EDM_DRO] Re: ACE Converter anomaly, REDWOOD

----- Original Message -----
From: <JanRwl@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, July 17, 2001 11:14 AM
Subject: Re: [CAD_CAM_EDM_DRO] Re: ACE Converter anomaly, REDWOOD


> In a message dated 16-Jul-01 16:26:18 Central Daylight Time,
KM6VV@...
> writes:
>
>
> > and the "end" grain
> > of the board splintered when the cutter began to leave the stock.
>
> This is hard to believe! Normally, particularly with something like
redwood,
> exiting the end-grain with any router or 2-flute mill-bit will come out
100%
> clean! And, if sharp, only slight tear-out when coming out the "side" of
a
> board! I mill wood often with excellent results. Just crank it up to
3000+
> RPM, and rotating the hand-wheels about as fast as you can by hand will do
> fine!
>
>
> [Non-text portions of this message have been removed]
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>