Re: ACE Converter anomaly, REDWOOD

Hi Jan,

That's probably part of the program, the mill wasn't running NEAR that
fast! The endmill, the RF-31 MILL, and the operator(s) were all new!

Alan KM6VV (and Son Pat)


JanRwl@... wrote:

>
> In a message dated 16-Jul-01 16:26:18 Central Daylight Time, KM6VV@...
> writes:
>
> > and the "end" grain
> > of the board splintered when the cutter began to leave the stock.
>
> This is hard to believe! Normally, particularly with something like redwood,
> exiting the end-grain with any router or 2-flute mill-bit will come out 100%
> clean! And, if sharp, only slight tear-out when coming out the "side" of a
> board! I mill wood often with excellent results. Just crank it up to 3000+
> RPM, and rotating the hand-wheels about as fast as you can by hand will do
> fine!
>
> [Non-text portions of this message have been removed]
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/