Re: Success at Last!
Posted by
Jon Elson
on 1999-09-28 21:48:51 UTC
stratton@... wrote:
first to edit the tool table, but now can edit any file on disk, as well
as the currently selected part program, or the setup file.
the axis scaling and servo parameters update. Very nice for servo
tuning.
Jon
> From: stratton@...True, it doesn't need it, but it HAS a primitive editor. It was included
>
> > Another feature of AHHA is an
> > internal editor which allows you to edit a gcode file,
> > again without exiting the main program.
>
> EMC doesn't need this as it runs under a multitasking operating
> system.
first to edit the tool table, but now can edit any file on disk, as well
as the currently selected part program, or the setup file.
> Editing the configuration files while the program is running is moreIt DOES allow the config file to be re-processed, making at least
> uncertain - you would probably have to restart emc before the changes
> take effect - but you don't have to close your editor, unless you run
> into a file locking problems. Certain unix programs and utilities have
> the ability to accept a "re-read config file" command(signal) while
> they are running - perhaps that could be added.
the axis scaling and servo parameters update. Very nice for servo
tuning.
Jon
Discussion Thread
Bob Bachman
1999-09-26 21:33:58 UTC
Success at Last!
Jon Anderson
1999-09-26 21:36:22 UTC
Re: Success at Last!
batwings@x...
1999-09-26 18:40:22 UTC
Re: Success at Last!
Robert Bachman
1999-09-28 09:12:25 UTC
Re: Success at Last!
stratton@x...
1999-09-28 06:30:56 UTC
Re: Success at Last!
Robert Bachman
1999-09-28 10:37:51 UTC
Re: Success at Last!
Tim Goldstein
1999-09-28 08:01:24 UTC
Re: Success at Last!
Jon Elson
1999-09-28 21:48:51 UTC
Re: Success at Last!
batwings@x...
1999-09-28 18:31:08 UTC
Re: Success at Last!
Dan Falck
1999-09-29 16:30:43 UTC
Re: Success at Last!
lorenzojose2000
2002-03-24 08:40:28 UTC
Re: archive update and request fo input