Re: [CAD_CAM_EDM_DRO] CNCpro Parallel port problem

> I am using DeskNC in an IBM Thinkpad 760C to Dan's 2A board controlling a
> Sherline Mill.
> All perform fine.
> I recently installed CNCpro which also works fine on initial installation.
> Here is the problem: When the computer is shut down and rebooted, CNCpro
> will no longer control the mill. No signals sent via the parallel port to
> the control board. The x,y,z numbers on the screen change with jog

commands

> and G-Code programs run ok (watching the numbers change).
> Re-loading CNCpro has no effect. The only way I can get it to run again,
> is to remove the program via the Add/Remove switch, shut down the

computer,

> and then reload from the Zip disk, and reconfigure the port settings.
> The LPT1 port is 03BC (according to system info) and that is the setting I
> use from the CNCpro menu.
> The port address used with DeskNC however, is 956. Don't recall why, but
> arrived at that setting after consultation with Dan when I built the board
> several years ago.
> If anyone can shed some light onto this dilemma I would be most grateful.
> Don
>

Don,

Can't help much except to tell you that decimal 956 is 3BC in hexidecimal.
So they are one in the same. Apparantly DeskNC uses decimal and CNCPro
uses hex. As far as the other problem goes, sorry, can't help.

Bill