Re: Re: EMC Lathe mode.

From: Jon Elson <elson@...>

>Brian Pitt wrote:

<s>

>> a preset tool change position (X positive limit) and just use T020202
>> (tool 2 ,  pocket 2 , offset 2) calling that tool with a 2nd offset
>would be
>> T020222

<s>The T020202 you mention is also a non-standard

>use of the tool word.  A D word following the T word provides the correct
>offsets for the selected t.

Jon, Brian

My Fagor 8025 uses M06 for a tool change and T##.## where the left of the
dot is the tool number between 1 and 99 and the right of the dot is the
offset between 1 and 32.

HTH

Ray