CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: setting up the CNC mill

Posted by ccs@m...
on 2001-10-28 19:29:52 UTC
> Do you mean that if you execute G01 X-1 and G01 X+1 once it returns to
> almost 1.000 but is off by some small delta, but if you repeat this many
> times it drifts away from 1.000 a little more with each execution? If it
> doesn't return to the same point after each loop it's more than a
> backlash problem.

The other possibility (other than missing step) to consider is that a
sprocket or coupling might be slipping on a shaft. Set screws are simply
not reliable... although I've got two machines full of them at the moment.
Locktite is my friend, but I'm sure it will fail someday when I least
expect it - need to redo everything right.

Chris

Discussion Thread

Boris Maraž 2001-10-28 08:44:45 UTC setting up the CNC mill currinh@O... 2001-10-28 17:05:44 UTC Re: setting up the CNC mill currinh@O... 2001-10-28 17:30:41 UTC Machinable Wax, Foam, etc. Brian Pitt 2001-10-28 17:57:47 UTC Re: [CAD_CAM_EDM_DRO] Machinable Wax, Foam, etc. Doug Harrison 2001-10-28 17:59:47 UTC Re: [CAD_CAM_EDM_DRO] Machinable Wax, Foam, etc. David M. Munro 2001-10-28 19:10:41 UTC Re: [CAD_CAM_EDM_DRO] Machinable Wax, Foam, etc. ccs@m... 2001-10-28 19:29:52 UTC Re: [CAD_CAM_EDM_DRO] Re: setting up the CNC mill FIK 2001-10-28 20:02:00 UTC Re: [CAD_CAM_EDM_DRO] Re: setting up the CNC mill FIK 2001-10-28 20:31:07 UTC Re: [CAD_CAM_EDM_DRO] Machinable Wax, Foam, etc. Jon Elson 2001-10-28 22:55:10 UTC Re: [CAD_CAM_EDM_DRO] Machinable Wax, Foam, etc. Jon Elson 2001-10-28 23:08:01 UTC Re: [CAD_CAM_EDM_DRO] Re: setting up the CNC mill dkowalcz@d... 2001-10-28 23:08:16 UTC Re: setting up the CNC mill vrojas 2001-10-29 00:19:00 UTC Re: [CAD_CAM_EDM_DRO] Re: setting up the CNC mill Boris Maraž 2001-11-03 10:57:02 UTC Re: [CAD_CAM_EDM_DRO] Re: setting up the CNC mill cncdxf@a... 2001-11-03 11:15:59 UTC Re: setting up the CNC mill Chris L 2001-11-03 11:53:06 UTC Re: [CAD_CAM_EDM_DRO] Re: setting up the CNC mill ccs@m... 2001-11-03 12:10:22 UTC Re: [CAD_CAM_EDM_DRO] Re: setting up the CNC mill