RE: [CAD_CAM_EDM_DRO] Re: 2.5 axis vs. 3 axis

> -----Original Message-----
> From: yethdear0 [mailto:yethdear@...]
> Sent: Wednesday, December 05, 2001 9:40 PM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] Re: 2.5 axis vs. 3 axis
>
>
> Wow!
>
> I must have received 20 messages about this "dome" thing today. My
> intent was for you fellow techno nerds out there to try and construct
> the dome geometry using your current CAM software. This will let you
> know if your software has the whoopee to do full and true 3D.
>
> So it looks like I'll make a dome program. Give me a day or so, so I
> can put out some other fires I have going on. I will send a copy of
> this dome program to those of you that have forwarded your e-mail
> addresses to me and I will also post the program on the "Files" area
> of Yahoo that correspond to this group.
>
> The program will be basically point to point and everything will
> be "G1" linear feed mode or "G0" rapid moves. This should run on most
> of the controls out there with very little editing. When machining
> true 3D there are no canned cycles or special routines, everything is
> point to point. I will also send/post setup instructions for the
> program too.
>
> Will get back to all of you in a day or so.
>
> Thanks….yethdear
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>