RE: [CAD_CAM_EDM_DRO] Re: 2.5 axis vs. 3 axis

Same here, I would like to try this on EMC.

John Guenther
Sterling Virginia

> -----Original Message-----
> From: John Barnwell [mailto:Barnwell@...]
> Sent: Wednesday, December 05, 2001 3:00 PM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: RE: [CAD_CAM_EDM_DRO] Re: 2.5 axis vs. 3 axis
>
>
> Somewhere I missed an address.
>
> Who ever posted this bit please email me the the program (which I
> assume is
> a list of G-codes)
>
> JB
>
> John Barnwell
> barnwell@...
> Voice: 978-534-4096
> Cell: 978-807-8475
>
> > As for your machine and its control, if you would like to see if it
> > can do full and true 3D contouring then e-mail at
> > yethdear@... and I will send you a program to run on your
> > Sherline mill that will cut this dome shape. This is a simple program
> > to use to verify what your machine capabilities are. The worst that
> > will happen is your machine will not simultaneously move all 3 axis
> > at the same time when it reads a line of data that includes an X, Y
> > and Z values all on the same line. It will move the X and Y first
> > then the Z axis last and separately. The result will be a big gouge
> > in your part. For this reason, you should use a piece of machining
> > wax, balsa foam, or even a piece of wood so that there is no damage
> > to your machine or cutting tool if the machine gouges the part.
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>