Re: [CAD_CAM_EDM_DRO] Precision
Posted by
Alan Marconett KM6VV
on 2001-12-06 18:12:18 UTC
Hi Chris,
Sounds like your axis are not perpendicular. It's not the axis itself,
rather, it is the relationship between the two (or 3, how about Z?).
Alan KM6VV
Chris Clough wrote:
Sounds like your axis are not perpendicular. It's not the axis itself,
rather, it is the relationship between the two (or 3, how about Z?).
Alan KM6VV
Chris Clough wrote:
>
> Ok... doing some testing with the CNC, just trying to figure out my
> error in the building of the table.
> My y-gantry works quite well, very straight cuts. I'm using a plasma
> torch for the cutting system by the way. My problem is when cutting a
> square two edges are perfectly parallel, but the other two are angle
> (1/32" deviance).
> So... is this problem in the x-axis? It usually occurs when it's going
> that direction (table wise)
> Any help would be great,
> -Chris Clough
> Xtech Engineering
Discussion Thread
Dany Tremblay
2001-12-06 16:43:11 UTC
BALL SCREW INFO
Art Fenerty
2001-12-06 18:00:24 UTC
Re: [CAD_CAM_EDM_DRO] BALL SCREW INFO
Chris Clough
2001-12-06 18:07:15 UTC
Precision
Alan Marconett KM6VV
2001-12-06 18:12:18 UTC
Re: [CAD_CAM_EDM_DRO] Precision
Chris Clough
2001-12-06 18:15:31 UTC
RE: [CAD_CAM_EDM_DRO] Precision
Alan Marconett KM6VV
2001-12-06 18:42:31 UTC
Re: [CAD_CAM_EDM_DRO] Precision
currinh@O...
2001-12-06 18:53:17 UTC
Re: BALL SCREW INFO
JanRwl@A...
2001-12-06 19:19:10 UTC
Re: [CAD_CAM_EDM_DRO] BALL SCREW INFO
Bob Campbell
2001-12-06 19:28:54 UTC
Re: [CAD_CAM_EDM_DRO] Precision
Bill Vance
2001-12-07 02:08:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: BALL SCREW INFO
Keith Rumley
2001-12-07 09:29:34 UTC
Re: [CAD_CAM_EDM_DRO] BALL SCREW INFO
N & K McLellan
2001-12-08 05:57:42 UTC
Re: [CAD_CAM_EDM_DRO] Precision
Chris Clough
2001-12-09 22:14:46 UTC
Servos & Encoders
Jon Elson
2001-12-09 22:18:24 UTC
Re: [CAD_CAM_EDM_DRO] Servos & Encoders