Re: [CAD_CAM_EDM_DRO] Dolphin Cad / Cam

Has anyone here had much experience with Dolphin Cad/Cam?

I need to know if the post processor can be customized for any CNC controller
so that one doesn't need to do a lot of editing after the geometry is drawn
and processed. My customer had been advised, by someone else, that BobCad
was the way to go. However, they have NO experience and therefore would like
a relatively inexpensive software package that will allow them to go from the
geometry drawing to the CNC program, including any custom M codes, etc.,
without the need to create Macros and then insert them into the code via and
editor.

Also, will Dolphin support the mixed use of absolute and incemental values
and multiple subroutines with nesting?

Their website doesn't really answer many questions but what I see does look
good.

Any help will be greatly appreciated.

Regards,

Randy Abernathy
4626 Old Stilesboro Road
Acworth, GA 30101
Ph/Fax: 770-974-5295
E-mail: cnc002@...
We service, install and repair industrial woodworking machinery
Specializing in SCM / SCMI machinery


[Non-text portions of this message have been removed]