Re: Spindle motor drive belts MAXNC 10
Posted by
Jon Anderson
on 1999-11-04 06:11:52 UTC
Jon Elson wrote:
rpm. This is well beyond Sherline design specs. One thing I've done to
help bearings last is reduce belt tension. By most anyone's standards,
I'm running a loose belt. Spindle mass is greatly reduced with the small
pulley I'm using and I have no problems with either belt slipping, or
wear. Been using the same belt for close to 2 years now.
Jon
> Are you getting the belts tight enough? If they are a bit loose,As I mentioned earlier, I'm running a Sherline spindle to over 7,000
> and slipping, it could wear down the driving surface.
rpm. This is well beyond Sherline design specs. One thing I've done to
help bearings last is reduce belt tension. By most anyone's standards,
I'm running a loose belt. Spindle mass is greatly reduced with the small
pulley I'm using and I have no problems with either belt slipping, or
wear. Been using the same belt for close to 2 years now.
Jon
Discussion Thread
hansw
1999-11-03 20:23:59 UTC
Re: Spindle motor drive belts MAXNC 10
Jon Anderson
1999-11-03 20:29:01 UTC
Re: Spindle motor drive belts MAXNC 10
hansw
1999-11-03 20:41:40 UTC
Re: Spindle motor drive belts MAXNC 10
WAnliker@x...
1999-11-03 20:48:27 UTC
Re: Spindle motor drive belts MAXNC 10
hansw
1999-11-03 21:19:28 UTC
Re: Spindle motor drive belts MAXNC 10
hansw
1999-11-03 21:26:56 UTC
Re: Spindle motor drive belts MAXNC 10
Jon Elson
1999-11-03 21:58:34 UTC
Re: Spindle motor drive belts MAXNC 10
PTENGIN@x...
1999-11-04 02:08:21 UTC
Re: Spindle motor drive belts MAXNC 10
Jon Anderson
1999-11-04 06:11:52 UTC
Re: Spindle motor drive belts MAXNC 10
Jon Anderson
1999-11-04 06:17:55 UTC
Re: Spindle motor drive belts MAXNC 10
Darrell Gehlsen
1999-11-04 12:25:09 UTC
Re: Spindle motor drive belts MAXNC 10
Paul Devey
1999-11-04 13:06:40 UTC
Re: Spindle motor drive belts MAXNC 10
Jon Anderson
1999-11-05 06:09:28 UTC
Re: Spindle motor drive belts MAXNC 10