Re: [CAD_CAM_EDM_DRO] small router collet(s) was Re: What kind of motor should I use?

The new Sherline pulley modification can spin at 10,200 RPM, continuously
adjustable from 0. I think the pulley set is about $75. I have installed
this on my mill and it works very nicely.

Daniel J. Statman, Statman Designs
www.statmandesigns.com

----- Original Message -----
From: "Henrik Olsson" <henrik-olsson@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, February 04, 2002 3:54 PM
Subject: Re: [CAD_CAM_EDM_DRO] small router collet(s) was Re: What kind of
motor should I use?


> Thanks Ballendo!
> What about the high RPM's on router like this? Even 8000 sounds a lot for
> plastics and aluminum. My goal is to mill/route and engrave aluminum,
brass
> and plastics. I have been thinking of buying a Sherline spindle but I just
> can't make up my
mind......Sherline......router.......router......Sherline.
> Thanks!
> /Henrik Olsson.
>
> ----- Original Message -----
> From: "ballendo" <ballendo@...>
>
> > Henrik,
> >
> > Rotozip makes an adapter that fits in a 1/4 collet, to take their 1/8
> > shank bits. Works well in most routers, IMO. Available at home depot.
> > (and works with other 1/8 shank tooling)
> >
> > Hope this helps.
> >
> > Ballendo
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>