Re: Heatsinking the G210's ??
Posted by
mariss92705
on 2002-02-15 13:00:29 UTC
Sean,
The connectors are removable. They are split into two sections of six
each. Just put your fore-finger under the connector and your thumb on
top. Just pull upwards on it. It will take about 10 lbs of force to
remove them.
Mariss
The connectors are removable. They are split into two sections of six
each. Just put your fore-finger under the connector and your thumb on
top. Just pull upwards on it. It will take about 10 lbs of force to
remove them.
Mariss
--- In CAD_CAM_EDM_DRO@y..., "audiomaker2000" <audiomaker@s...> wrote:
> Thanks Doug,
> drives are like my drives (and I bet they are), then there is no
way
> to bolt from the top. The only way I could see would be to measure
> the spacing between the original machine screws and pull them out
and
> bolt it from the back. That could be a real PITA since I'd have to
> drill between cooling fins with concave "valleys". At this point I
am
> considering this a design flaw. Perhaps Gecko would create an
option
> of having that wafer with tabs you could bolt through.
> I suspect I will get an answer that will prove that I'm totally
> missing the obvious.
>
> Sean
Discussion Thread
audiomaker2000
2002-02-14 19:35:39 UTC
Heatsinking the G210's ??
Doug Fortune
2002-02-14 19:51:24 UTC
Heatsinking the G210's ??
audiomaker2000
2002-02-14 20:37:22 UTC
Re: Heatsinking the G210's ??
Alan Marconett KM6VV
2002-02-14 20:48:14 UTC
Re: Heatsinking the G210's ??
JanRwl@A...
2002-02-14 20:51:20 UTC
Re: [CAD_CAM_EDM_DRO] Heatsinking the G210's ??
audiomaker2000
2002-02-14 21:18:52 UTC
Re: Heatsinking the G210's ??
JanRwl@A...
2002-02-14 21:38:39 UTC
Re: [CAD_CAM_EDM_DRO] Heatsinking the G210's ??
JanRwl@A...
2002-02-14 21:50:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Heatsinking the G210's ??
mariss92705
2002-02-15 13:00:29 UTC
Re: Heatsinking the G210's ??