CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Re: looking a power supply for gecko

on 2002-02-23 08:04:57 UTC
Luis:

You could find the necessary parts at Electronics Surplus (Cleveland), All
Electronics, or several other places. Dan Mauch also offers a power supply
kit on his Camtronics site.

However, if you're really unconfortable with assembling some parts, then I'd
agree that you're better off buying one already assembled.

I'm using a highly regulated supply with the Camtronics 2 Amp drivers
because I was too lazy to assemble the parts and found a used supply at an
attractive price. However, if you've been keeping up with the posts on this
group, you've heard that for stepper drivers, the unregulated supply may
actually be better than the regulated supply because of the interaction
between the load's current requirements and the supply's capabilities.

-- Jerry

|
|where I can find a capacitator & bridge rectifier? I know nothing
|about electronic and I do not know how to connect those stuff..
|I am wondering if I better buy a good power suppy..
|

Discussion Thread

luisguillermo98 2002-02-22 19:04:22 UTC looking a power supply for gecko High Tech 2002-02-22 20:47:35 UTC RE: [CAD_CAM_EDM_DRO] looking a power supply for gecko Guy Sirois 2002-02-23 06:59:03 UTC RE: [CAD_CAM_EDM_DRO] looking a power supply for gecko Bob Campbell 2002-02-23 07:13:50 UTC Re: [CAD_CAM_EDM_DRO] looking a power supply for gecko luisguillermo98 2002-02-23 07:25:32 UTC Re: looking a power supply for gecko Carol & Jerry Jankura 2002-02-23 08:04:57 UTC RE: [CAD_CAM_EDM_DRO] Re: looking a power supply for gecko luisguillermo98 2002-02-26 20:05:51 UTC Re: looking a power supply for gecko Bob Campbell 2002-02-27 08:10:03 UTC RE: [CAD_CAM_EDM_DRO] Re: looking a power supply for gecko Peter 2002-02-27 08:38:55 UTC Re: [CAD_CAM_EDM_DRO] Re: looking a power supply for gecko luisguillermo98 2002-02-28 20:57:26 UTC Re: looking a power supply for gecko wanliker@a... 2002-02-28 21:26:33 UTC Re: [CAD_CAM_EDM_DRO] Re: looking a power supply for gecko JanRwl@A... 2002-03-01 19:26:23 UTC Re: [CAD_CAM_EDM_DRO] Re: looking a power supply for gecko