Re: +5V
Posted by
deanc500
on 2002-03-17 21:21:22 UTC
--- In CAD_CAM_EDM_DRO@y..., "meneercen" <meneercen@y...> wrote:
+5v regulator, and two 12V relay drivers.
Dean
plaza.powersurfr.com/deanc
> Hi,Hi, I have parallel breakout boards available on my site. They have a
>
> From previous posts, it is clear that the best solution to provide
> the +5V for the Gecko drives is to tap it from the PC itself.
> However, if one is to use a notebook computer, even if that can be
> done easily, I think one would be very about tapping the +5V from the
> notebook. I hope to provide for an independent source of +5V from the
> power supply of 48V. What is the best way to provide for this?
>
> Thanks in advance.
>
> Meneer
+5v regulator, and two 12V relay drivers.
Dean
plaza.powersurfr.com/deanc
Discussion Thread
meneercen
2002-03-17 11:13:36 UTC
+5V
Tom Benedict
2002-03-17 12:41:45 UTC
Re: [CAD_CAM_EDM_DRO] +5V
Al Schoepp
2002-03-17 12:47:02 UTC
Re: [CAD_CAM_EDM_DRO] +5V
Tom Benedict
2002-03-17 13:08:12 UTC
Re: [CAD_CAM_EDM_DRO] +5V
Doug Fortune
2002-03-17 14:02:39 UTC
Re: [CAD_CAM_EDM_DRO] +5V
Dan Mauch
2002-03-17 14:06:34 UTC
RE: [CAD_CAM_EDM_DRO] +5V
Tim Goldstein
2002-03-17 16:15:43 UTC
RE: [CAD_CAM_EDM_DRO] +5V
RC
2002-03-17 17:02:57 UTC
Re: [CAD_CAM_EDM_DRO] +5V
Bob Campbell
2002-03-17 17:13:41 UTC
RE: [CAD_CAM_EDM_DRO] +5V
deanc500
2002-03-17 21:21:22 UTC
Re: +5V
meneercen
2002-03-19 22:04:34 UTC
+5V
Doug Fortune
2002-03-19 23:35:09 UTC
Re: [CAD_CAM_EDM_DRO] +5V
Tim Goldstein
2002-03-20 08:56:25 UTC
Re: [CAD_CAM_EDM_DRO] +5V
aspaguy
2002-03-20 18:47:11 UTC
Re: +5V
Alan Marconett KM6VV
2002-03-20 19:55:01 UTC
Re: [CAD_CAM_EDM_DRO] Re: +5V
Dan Mauch
2002-03-21 06:53:59 UTC
RE: [CAD_CAM_EDM_DRO] Re: +5V