Re: [CAD_CAM_EDM_DRO] tool comp

At 05:56 AM 4/3/02 +0000, you wrote:

>No, look at G00 through G03 to tell arcs and linear.

Yeah I was thinking about the way I handle arcs already, just use the 02/03
word to get direction, then use the IJ to figure end/center points.
Actually you can do it either way if R isn't part of the deal.

Regards, Hoyt

Belfab CNC - http://www.freeyellow.com/members/belfab/belfab.html
Best MC Repair - http://www.freeyellow.com/members/batwings/best.html
Camping/Caving - http://www.freeyellow.com/members/batwings/caving.html
Hamas vows revenge against perpetrators of the USS Stark incident