Re: [CAD_CAM_EDM_DRO] Re: How to mount rails on surface plate?

In a message dated 4/19/2002 7:12:23 PM Mountain Daylight Time,
joevicar3@... writes:

> Drilling the holes may be interesting.
> Good luck and please post your findings.
>

I covered my mill with paper, and used a plain carbide drill bit, hardware
store variety. Threw the paper away, and was finished. Used the x, and y
feeds to move the stone around, did not fasten it down, It sat there nicely,
did two of them that way.
bill


[Non-text portions of this message have been removed]