Re: rough motor - loose cable

on 2002-05-06 02:01:13 UTC

It wasn't the troll, but a loose cable. Everything working now. Thanks

For relative new-comers - if ever meet a similar problem, CHECK YOUR
CABLES first before meddling with the board.

BTW to check logic side of the Gecko, I wonder if it is possible to
measure the voltage across terminals 11-12. Perhaps when the drive is
stepping, the voltage across terminals 11-12 will increase?

Thanks

Discussion Thread

ballendo 2002-05-01 03:16:09 UTC OT Banned from YeagerAutomation dave_ace_me 2002-05-01 04:55:02 UTC Re: OT Banned from YeagerAutomation art 2002-05-01 08:32:41 UTC Re: [CAD_CAM_EDM_DRO] Re: OT Banned from YeagerAutomation cadcamcenter 2002-05-03 23:02:51 UTC Re: OT Banned from YeagerAutomation Sven Peter 2002-05-04 05:49:13 UTC Re: [CAD_CAM_EDM_DRO] Re: OT Banned from YeagerAutomation keongsan 2002-05-05 19:47:10 UTC rough motor mariss92705 2002-05-05 22:42:39 UTC Re: rough motor keongsan 2002-05-06 00:00:20 UTC Re: rough motor keongsan 2002-05-06 00:16:33 UTC Re: rough motor keongsan 2002-05-06 00:48:00 UTC Re: rough motor keongsan 2002-05-06 02:01:13 UTC Re: rough motor - loose cable Dan Mauch 2002-05-06 06:47:36 UTC RE: [CAD_CAM_EDM_DRO] Re: rough motor Jon Elson 2002-05-06 10:40:02 UTC Re: [CAD_CAM_EDM_DRO] Re: rough motor