Re: [CAD_CAM_EDM_DRO] Re: stable EMC version?
Posted by
Tim Goldstein
on 2002-05-20 12:00:24 UTC
I forget which version, but it may have been 2.09 or 2.10. I did have the
problem with both screen entry in manual mode and using a G92 in MDI mode.
Also have problems that it would sometimes not recognize the offset to the
screen (make the change and the coordinates stay the same).
Tim
[Denver CO]
problem with both screen entry in manual mode and using a G92 in MDI mode.
Also have problems that it would sometimes not recognize the offset to the
screen (make the change and the coordinates stay the same).
Tim
[Denver CO]
----- Original Message -----
> Whew! Is this still the current condition of the latest BDI? I am
starting to
> set up to port all my parallel port hardware to BDI, but maybe I should
> reconsider. I have BDI 2-12.
>
> Do you know if the coordinate offset from the screen is the problem, or
does
> a G92 entered in the MDI window cause the same problem?
>
> I had a problem once where interrupting a programmed 2 (or 3) axis move
> could cause a later jog operation to move more than the axis you were
jogging.
> The motion code was trying to complete the interrupted move on the axis
> you were not jogging. I think that one was cleared up, but rumors are
that it
> shows up once in a while.
>
> Jon
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
Discussion Thread
patrick@h...
2002-05-19 13:02:03 UTC
stable EMC version?
Tim Goldstein
2002-05-19 13:22:37 UTC
RE: [CAD_CAM_EDM_DRO] stable EMC version?
Jon Elson
2002-05-19 23:39:51 UTC
Re: [CAD_CAM_EDM_DRO] stable EMC version?
stevenson_engineers
2002-05-20 02:39:47 UTC
Re: stable EMC version?
Tim Goldstein
2002-05-20 08:41:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: stable EMC version?
Jon Elson
2002-05-20 09:36:04 UTC
Re: [CAD_CAM_EDM_DRO] Re: stable EMC version?
Jon Elson
2002-05-20 09:45:19 UTC
Re: [CAD_CAM_EDM_DRO] Re: stable EMC version?
j.guenther
2002-05-20 10:10:20 UTC
RE: [CAD_CAM_EDM_DRO] Re: stable EMC version?
Tim Goldstein
2002-05-20 12:00:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: stable EMC version?
Les Watts
2002-05-20 15:25:45 UTC
Re: [CAD_CAM_EDM_DRO] Re: stable EMC version?
John Guenther
2002-05-20 16:23:55 UTC
RE: [CAD_CAM_EDM_DRO] Re: stable EMC version?
Les Watts
2002-05-20 16:37:11 UTC
Re: [CAD_CAM_EDM_DRO] Re: stable EMC version?
Matt Shaver
2002-05-20 18:07:35 UTC
Re: [CAD_CAM_EDM_DRO] Re: stable EMC version?