Re: VectorCad opinions

<snip>

> I use Dolphin Partmaster CadCam, and as far as I am aware, it is

> me one low cost LATHE repeat Lathe!! program, in pounds OR dollars
> that can do the ALL the following:-
> Rought turning
> Finish turning
> Contouring
> Groove,
> Part off
> Screwcut
> Support both front and back tools in the same program.
> Work with a defined blank shape, ie a casting or forging.
> Write the code for simple parts without a drawing by MDI.

John,

Dolphin must be a very popular program in the UK.

Vector can do all that and more. In fact there has not been anything
that I could not do that I needed to do with Vector. You just need
to understand how the program works. Programmers with little
patients will give up on it too quickly and toss it aside.

Wayne