CAD CAM EDM DRO - Yahoo Group Archive

Re: acceleration profille

Posted by cadcambee
on 2002-07-26 17:21:48 UTC
--- In CAD_CAM_EDM_DRO@y..., "Dave Hylands" <dhylands@b...> wrote:
> I have a question about the acceleration parameter.
>
> What does an acceleration parameter of 1000 sps really mean?
>
> I'm assuming that sps is steps per second. Does that mean it will
increase
> the rate of pulses from 0/second to 1000/second over a one second
period?


I believe the correct units for acceleration is 1000 steps per sec.
per sec or 1000steps/sec. squared. It is really hard to represend the
(sec. power of 2) When is some genius programmer going to allow us to
do that over the net?

Peter

Discussion Thread

keongsan 2002-07-26 02:01:35 UTC acceleration profille Dan Mauch 2002-07-26 11:19:31 UTC RE: [CAD_CAM_EDM_DRO] acceleration profille Dave Hylands 2002-07-26 11:31:42 UTC RE: [CAD_CAM_EDM_DRO] acceleration profille cadcambee 2002-07-26 17:21:48 UTC Re: acceleration profille keongsan 2002-07-27 05:04:39 UTC Re: acceleration profille (gained steps?) jmkasunich 2002-07-27 12:26:06 UTC Re: acceleration profille Graham Hollis 2002-07-27 15:05:11 UTC Re: [CAD_CAM_EDM_DRO] Re: acceleration profille Michael Holm 2002-07-27 16:49:00 UTC Re: [CAD_CAM_EDM_DRO] acceleration profille jmkasunich 2002-07-27 17:02:37 UTC Re: acceleration profille Alan Marconett KM6VV 2002-07-27 17:30:05 UTC Re: [CAD_CAM_EDM_DRO] acceleration profille cadcambee 2002-07-27 18:08:52 UTC Re: acceleration profille mariss92705 2002-07-27 19:52:51 UTC Re: acceleration profille Alan Marconett KM6VV 2002-07-28 11:26:47 UTC Re: acceleration profille keongsan 2002-07-28 16:57:15 UTC Re: acceleration profille (gained steps?) keongsan 2002-07-28 17:01:16 UTC Re: acceleration profille (gained steps?) Steve Blackmore 2002-07-28 17:34:56 UTC Re: [CAD_CAM_EDM_DRO] Re: acceleration profille Dave Hylands 2002-07-28 18:00:37 UTC RE: [CAD_CAM_EDM_DRO] Re: acceleration profille (gained steps?) mariss92705 2002-07-28 18:20:29 UTC Re: acceleration profille (gained steps?) Alan Marconett KM6VV 2002-07-28 19:57:30 UTC Re: acceleration profille MIKEC@W... 2002-07-28 21:41:19 UTC Re: [CAD_CAM_EDM_DRO] Re: acceleration profille MIKEC@W... 2002-07-28 21:44:17 UTC Re: [CAD_CAM_EDM_DRO] acceleration profille chapmani 2002-07-29 02:11:59 UTC Re: acceleration profille eforum3001 2002-07-29 04:04:01 UTC Re: acceleration profille (gained steps?)