RE: [CAD_CAM_EDM_DRO] Re: acceleration profille (gained steps?)
Posted by
Dave Hylands
on 2002-07-28 18:00:37 UTC
> Is "gained steps" (as opposed to lost steps) impossible? Are thereGained should be just as possible as lost steps.
> any circumstances where an axis may move more than commanded or did I
> witness a mirage?
Lost steps happen when you send the steps faster than the motor can respond.
Similarly, if you were to get the motor going really fast, and then all of
sudden you just stop sending steps, then it's entirely believable that the
motor will continue to move even though no steps are sent (due to momentum).
Which is why deceleration is as important as acceleration.
Dave Hylands
Discussion Thread
keongsan
2002-07-26 02:01:35 UTC
acceleration profille
Dan Mauch
2002-07-26 11:19:31 UTC
RE: [CAD_CAM_EDM_DRO] acceleration profille
Dave Hylands
2002-07-26 11:31:42 UTC
RE: [CAD_CAM_EDM_DRO] acceleration profille
cadcambee
2002-07-26 17:21:48 UTC
Re: acceleration profille
keongsan
2002-07-27 05:04:39 UTC
Re: acceleration profille (gained steps?)
jmkasunich
2002-07-27 12:26:06 UTC
Re: acceleration profille
Graham Hollis
2002-07-27 15:05:11 UTC
Re: [CAD_CAM_EDM_DRO] Re: acceleration profille
Michael Holm
2002-07-27 16:49:00 UTC
Re: [CAD_CAM_EDM_DRO] acceleration profille
jmkasunich
2002-07-27 17:02:37 UTC
Re: acceleration profille
Alan Marconett KM6VV
2002-07-27 17:30:05 UTC
Re: [CAD_CAM_EDM_DRO] acceleration profille
cadcambee
2002-07-27 18:08:52 UTC
Re: acceleration profille
mariss92705
2002-07-27 19:52:51 UTC
Re: acceleration profille
Alan Marconett KM6VV
2002-07-28 11:26:47 UTC
Re: acceleration profille
keongsan
2002-07-28 16:57:15 UTC
Re: acceleration profille (gained steps?)
keongsan
2002-07-28 17:01:16 UTC
Re: acceleration profille (gained steps?)
Steve Blackmore
2002-07-28 17:34:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: acceleration profille
Dave Hylands
2002-07-28 18:00:37 UTC
RE: [CAD_CAM_EDM_DRO] Re: acceleration profille (gained steps?)
mariss92705
2002-07-28 18:20:29 UTC
Re: acceleration profille (gained steps?)
Alan Marconett KM6VV
2002-07-28 19:57:30 UTC
Re: acceleration profille
MIKEC@W...
2002-07-28 21:41:19 UTC
Re: [CAD_CAM_EDM_DRO] Re: acceleration profille
MIKEC@W...
2002-07-28 21:44:17 UTC
Re: [CAD_CAM_EDM_DRO] acceleration profille
chapmani
2002-07-29 02:11:59 UTC
Re: acceleration profille
eforum3001
2002-07-29 04:04:01 UTC
Re: acceleration profille (gained steps?)