Re: Newbie

Hi vanja,

I use the SMC1500 (from Conrad) and had some problems to get it
working. Carl of deskam (www.deskam.com) adjusted DeskNC, so that it
works. The problem is that it's not step and direction drive or phase
drive. Good luck
Hugo






th--- In CAD_CAM_EDM_DRO@y..., "Vanja Bubic" <vanja@t...> wrote:

> Hi Everybody, I am new to this list, and new to CNC basically.
> I have one question regarding EMC software...
> We have SMC800 Interface card which runs on Parallel port...is that

card supported by EMC, basically the question is should I bother
downloading whole iso file (linux+emc) or should I continue search
for cnc software that works with my card?

>
> Thank in advance
>
> Best Regards,
> Vanja