Re: It's ALIVE!!!

--- In CAD_CAM_EDM_DRO@y..., "Tim Goldstein" <timg@k...> wrote:
> If you have near recent Gecko G2xx drives you would have idle
current
> reduction. That should keep the motors from getting very hot at all
when
> they are idling. You did not mention what voltage you are using or
the
> current you are set for. If the voltage is pushing up towards 25X
over
> voltage or your current is set too high you will get lots of heat.
>
> Tim
> [Denver CO]
> Sherline Products at Deep Discount
> Mach1 & DeskCNC with Credit Card ordering
> Ask about Sherline and DeskCNC bundle discounts
> www.KTMarketing.com/Sherline
>
> > -----Original Message-----
> > I finally got everything straight in Mach1 and my setup is now
> > functioning. Now just need to figure out my settings for my
motor.
> > More research.
> >
> > Are the motors supposed to be getting hot setting idle. Mine
feel
> > very hot.
> >
> > Thanks,
> >
> > Barclay
> >
> >
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html