Re: [CAD_CAM_EDM_DRO] Re: It's ALIVE!!!

I'm using a 6 volt 1.2 A motor running at 24V and I have a 10k 5% resistor
on the gecko drive. I don't know how they are wired right now. Marriss
told me how to hook them up to his gecko. 6-wire using 4 to the drive is
all I know. I'm researching more to find out this.

----- Original Message -----
From: "Tim Goldstein" <timg@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, November 29, 2002 10:26 PM
Subject: RE: [CAD_CAM_EDM_DRO] Re: It's ALIVE!!!


> Well, it is not the voltage that is the problem. What are the ratings on
> the motors and how do you have it wired (half coil, full coil (series),
> parallel)?
>
> Tim
> [Denver CO]
> Sherline Products at Deep Discount
> Mach1 & DeskCNC with Credit Card ordering
> Contact me for discounts on DeskCNC & Sherline bundles
> www.KTMarketing.com/Sherline
>
> > -----Original Message-----
> >
> > Ooops, I mean 24volt and 1.2Amp
> >
> > Barclay
> >
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>