RE: [CAD_CAM_EDM_DRO] It's ALIVE!!!

If you have near recent Gecko G2xx drives you would have idle current
reduction. That should keep the motors from getting very hot at all when
they are idling. You did not mention what voltage you are using or the
current you are set for. If the voltage is pushing up towards 25X over
voltage or your current is set too high you will get lots of heat.

Tim
[Denver CO]
Sherline Products at Deep Discount
Mach1 & DeskCNC with Credit Card ordering
Ask about Sherline and DeskCNC bundle discounts
www.KTMarketing.com/Sherline

> -----Original Message-----
> I finally got everything straight in Mach1 and my setup is now
> functioning. Now just need to figure out my settings for my motor.
> More research.
>
> Are the motors supposed to be getting hot setting idle. Mine feel
> very hot.
>
> Thanks,
>
> Barclay
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html