Re: [CAD_CAM_EDM_DRO] Re: extending linear rail by butting two pieces together
Posted by
William Scalione
on 2002-12-20 12:51:34 UTC
Eric,
I had some THK 15's machined on the ends, was quite easy according to the
guy who did them, No grinding required. He first took a file and scratched
the back of the rail, then declared he could do it without a problem.
Bill
I had some THK 15's machined on the ends, was quite easy according to the
guy who did them, No grinding required. He first took a file and scratched
the back of the rail, then declared he could do it without a problem.
Bill
> Eric,
>
> Aligning two pieces of THK on an 80/20 extrusion should not be a problem.
> From my experience, the THK rails on my 80/20 seem to self align.
>
> For two sections, I would first try them without grinding the ends. The
> chamfer that they put on them is very small. If at that point you are not
> happy with it, you could have the ends ground.
>
> Bob Campbell
>
>
> > Just curious - have the same situation (20mm THK rail). I have a
> > sherline mill, and wondering if i can just mill the ends off square?
> > I have called a few machine shops in the area, and they have either
> > said 'you need to grind them' or 'i have never heard of THK square
> > rails, are you sure they arent round?'
> >
> > Also - mounting to 8020 extrusion, and curious if there are tricks to
> > keeping the 'butt' aligned. (w/ key pushing the ends together,
> > etc...)
> > Thanks!
> > Eric
Discussion Thread
tig415
2002-11-17 14:23:26 UTC
extending linear rail by butting two pieces together
JanRwl@A...
2002-11-17 14:43:49 UTC
Re: [CAD_CAM_EDM_DRO] extending linear rail by butting two pieces together
William Scalione
2002-11-17 14:49:10 UTC
Re: [CAD_CAM_EDM_DRO] extending linear rail by butting two pieces together
Robert Campbell
2002-11-17 14:50:40 UTC
Re: [CAD_CAM_EDM_DRO] extending linear rail by butting two pieces together
dolph_and_nicole <dolph@s...
2002-12-20 06:22:59 UTC
Re: extending linear rail by butting two pieces together
Robert Campbell
2002-12-20 07:41:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: extending linear rail by butting two pieces together
tig415 <tig416@e...
2002-12-20 10:29:35 UTC
Re: extending linear rail by butting two pieces together
William Scalione
2002-12-20 12:51:34 UTC
Re: [CAD_CAM_EDM_DRO] Re: extending linear rail by butting two pieces together
doug king
2002-12-20 23:20:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: extending linear rail by butting two pieces together
Peter
2002-12-21 13:55:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: extending linear rail by butting two pieces together