Re: [CAD_CAM_EDM_DRO] A little experiment on demagnetization

"Mariss Freimanis " wrote:

> 1) I took two identical motors, (Rapidsyn 23D6209, 4.7A @ 1.7VDC)
> connected in full-winding mode and set the current to 2.4A per phase
> on a G201. The power supply was 25VDC.
>
> 2) I removed the rotor from one motor, waited 5 seconds, then
> replaced it. The other motor was unmolested and would serve as the
> baseline unit.

Did you measure both motors to make sure they were the same? You
most certainly can not assume that both were the same unless you
tested them. As written, your experiment was faulty and
conclusions meaningless. Note that I said - as written - so I
don't know if you made the equavalency experiment or not.

JerryK