Re: Help - G340 problem ?

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "ftomazz <filipetomaz@p...>"
<filipetomaz@p...> wrote:

> Filipe Tomaz, Portugal
>
> Hi there. I'm wiring one gecko and one servo motor.
> I think that all is ok, but I'm having a problem.
>
> -> When I power on, the motor starts imediatly.
> After power on, the fault goes on for about 1 second, then that motor
> starts without any control.
>
> I have 36Vdc on the gecko, commun ground configuration (inside the
> gecko) that is connected to the ground of the juntion board.
>
> For trying, if I use step and direction both connected to 5+ OR to
> commun ground, the same happens. But if both dir and step == 0 the
> motor should be still ?
>
>
> If you suspect of anything, ask me for more detail.

(TERM 3) ARM- RED motor lead
(TERM 4) ARM+ Black motor lead

Reverse and motor leads ,... page 6 of the gecko manual, FAULT
INDICATOR, number 6) The motor is wired backwards.

Frank

>
> For off list use filipetomaz (at) portugalmail.pt
>
> Thanks to all.