Re: Help - G340 problem ?

Dan,

Thanks for the feedback, that puts that one to rest.

Bernard

> No the problem turnout to be a problem with the wires not making

good

> contact with the connectors.The encoders were fine. I emailed Tomaz

off

> line with how to check the connections.
> Dan
>
> -----Original Message-----
> From: Bernard R <bwjarandall@c...>
> [mailto:bwjarandall@c...]
> Sent: Friday, February 14, 2003 10:18 AM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] Re: Help - G340 problem ?
>
>
> Filipe,
>
> This sounds very similar to the post that started 1/26/03 #56115
> Camtronics/Gecko troubleshooting. It turned out there was problems
> with some encoders.
>
> Bernard
>
> > Filipe Tomaz, Portugal
> >
> > Hi there. I'm wiring one gecko and one servo motor.
> > I think that all is ok, but I'm having a problem.
> >
> > -> When I power on, the motor starts imediatly.
> > After power on, the fault goes on for about 1 second, then that
> motor
> > starts without any control.
> >
> > I have 36Vdc on the gecko, commun ground configuration (inside the
> > gecko) that is connected to the ground of the juntion board.
> >
> > For trying, if I use step and direction both connected to 5+ OR to
> > commun ground, the same happens. But if both dir and step == 0

the

> > motor should be still ?
> >
> >
> > If you suspect of anything, ask me for more detail.
> >
> > For off list use filipetomaz (at) portugalmail.pt
> >
> > Thanks to all.
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@a...,
> timg@k...
> Moderator: pentam@c... indigo_red@q... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru Google.com to

reach it

> if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to

be a

> sister site to the CCED group, as many of the same members are

there,

> for OT subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING

THEM.

> DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........ bill
> List Mom List Owner
>
>
>
> Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/