Re: [CAD_CAM_EDM_DRO] Re: cnc router plans / Poor Man's Router

Frank,
That make sense, I'm not sure what I'll wind up building. You do show a
lot of good ideas.
Thanks for posting what you did.
Nill Higdon
dakota8833 wrote:

> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "ajv2803959
> <antonio-ximenez@t...>" <antonio-ximenez@t...> wrote:
>
>>Hi, have a look the next link
>>http://groups.yahoo.com/group/CAD_CAM_EMC/files/Millrouter%20/
>>You must be member
>>Plans are free and the guy has designed want to make wood working.
>>
>>Best Regards
>>
>>
>>--- In CAD_CAM_EDM_DRO@yahoogroups.com, "shrongk2000
>
> <armstrongsmbl@a...>" <armstrongsmbl@a...> wrote:
>
>>>hi
>>>my husband and I wish to start a furniture bussines and rather than
>>>buying a cnc router he wishes to build one. We have looked at some
>>>sites and the cost involved is too high as we are in Australia and
>>>the transfer in money is sooo expensive.
>>>We have had no luck in locating plans here and every one thinks
>>
>
>
> The SolidWorks files are there for anyone to get a rotating 3D look at
> the design not to copy it to a tee. I should point out that some
> changes have been made during the build ,.. if you look at the gif
> picts and then at the photo's you will see that I redesigned the
> gantry at the Y rails to get the full 50" of travel without changing
> the width of the gantry. The Y servo can flipped 180 and belt driven
> so it doesn't stick out. NOTE : I have not updated in files. I wanted
> to wait and run the machine throughly before I do. As for plans ,....
> well that's a lot of work, ...just don't if I have the time to write
> up a step by step.
>
> Frank