Re: [CAD_CAM_EDM_DRO] Re: Dyna-Myte 2400
Posted by
William Scalione
on 2003-02-28 21:37:14 UTC
Thanks, Ive seen that website, but he is using the nylon gears with his new
motors to drive the screws. I don't have them and probably would not use
them even if I did. I agree that timing belts and pulleys are the way to go.
Bill
motors to drive the screws. I don't have them and probably would not use
them even if I did. I agree that timing belts and pulleys are the way to go.
Bill
> Details of a Dyna-Myte conversion can be found at www.route-a-
> bout.com under the "how it started" link. Rick West designed the
> motor mounts, his email is on the bottom of the main page.
>
> timing belts and pulleys are the way to go. The original gears
> are much to weak for a nema23 motor.
Discussion Thread
William Scalione
2003-02-28 10:24:04 UTC
Dyna-Myte 2400
RichD
2003-02-28 16:38:18 UTC
Re: [CAD_CAM_EDM_DRO] Dyna-Myte 2400
aintknowwayzzsa <yonsi@s...
2003-02-28 20:27:45 UTC
Re: Dyna-Myte 2400
johnseale <johnseale@y...
2003-02-28 20:28:25 UTC
Re: Dyna-Myte 2400
RichD
2003-02-28 20:59:05 UTC
Re: [CAD_CAM_EDM_DRO] Dyna-Myte 2400
William Scalione
2003-02-28 21:37:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: Dyna-Myte 2400
William Scalione
2003-02-28 21:52:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: Dyna-Myte 2400
William Scalione
2003-02-28 22:05:03 UTC
Re: [CAD_CAM_EDM_DRO] Dyna-Myte 2400
Dan Mauch
2003-03-01 07:12:46 UTC
RE: [CAD_CAM_EDM_DRO] Re: Dyna-Myte 2400