CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Dyna-Myte 2400

on 2003-02-28 22:05:03 UTC
> Hi Bill,
> Myself and a nearby friends have these machines, 6 all together.
> I am in the middle of converting my DM2400.
> They are very robust for their size being solid iron.
> The leadscrews are ACME with various types of self adjusting plastic nuts.
> Each machine I have seen was different from all the others.
> It seems they were in constant developement.
> The drives are 10:1 (10T/100T gears) with 100 SPR stepper motors.
> A friend is converting his to size 23 modern steppers and 2.5:1 belt
drive.
> I may do the same after testing the present setup.
> The end bearing blocks are dowel pinned for precise alignment.
> Try not to disturb this.
> The machines perform very well, but be carefull to check for plugged lube
> lines (again there are several versions).
> The high wear item is the drive "nut" in the spindle pulley. With only 2
> grooves (splines), the iron nut gets sloppy and rattles very noisily.
> New ones are fabricated from brass or wire EDM cut from bearing bronze.
> I have the g-code file if anyone wants it.
> The belt is available (Gates).
> The original electronics are largely junk boxed and new designs
substituted.
> I have a few pics of a DM2000 I converted if you want-off list.
> RichD, Atlanta.


Hi Rich, thanks for the info.

As far as lube lines go I don't have any, just some grease or oil fittings
that I was going to remove, thread the holes and put some lines in there for
an auto lube system. The spindle seems to be tight and quiet. Overall in
nice condition, just needs some motors and electronics. I'll take some
photos of before, during, and after shots and post them when I'm done.
Sending you an offline message for the pics of the DM2000 and the g-code.

Bill

Discussion Thread

William Scalione 2003-02-28 10:24:04 UTC Dyna-Myte 2400 RichD 2003-02-28 16:38:18 UTC Re: [CAD_CAM_EDM_DRO] Dyna-Myte 2400 aintknowwayzzsa <yonsi@s... 2003-02-28 20:27:45 UTC Re: Dyna-Myte 2400 johnseale <johnseale@y... 2003-02-28 20:28:25 UTC Re: Dyna-Myte 2400 RichD 2003-02-28 20:59:05 UTC Re: [CAD_CAM_EDM_DRO] Dyna-Myte 2400 William Scalione 2003-02-28 21:37:14 UTC Re: [CAD_CAM_EDM_DRO] Re: Dyna-Myte 2400 William Scalione 2003-02-28 21:52:21 UTC Re: [CAD_CAM_EDM_DRO] Re: Dyna-Myte 2400 William Scalione 2003-02-28 22:05:03 UTC Re: [CAD_CAM_EDM_DRO] Dyna-Myte 2400 Dan Mauch 2003-03-01 07:12:46 UTC RE: [CAD_CAM_EDM_DRO] Re: Dyna-Myte 2400