What stepper wires to connect?
Posted by
Kevin
on 2003-05-14 16:18:03 UTC
I am in the process of hooking my 6 wire vextas up to my DeskCNC
controller. I thought my motors were like some shown in the file
section but they are not. Mine are PK268M-02A if that helps. Here is
a ascii copy of the diagram that came with them.
Blue Yellow Red
| | |
| | |
----////////////////////----
Green ------|
/ *
/ * *
/ * * *
White ------/ * *
/ *
/
/
Gray -------|
I tried red-yellow and green-white, but all my motor does is make
noise and vibrate, no shaft rotation. Am I using the correct wires
or do I have a different problem?
Thanks
Kevin
controller. I thought my motors were like some shown in the file
section but they are not. Mine are PK268M-02A if that helps. Here is
a ascii copy of the diagram that came with them.
Blue Yellow Red
| | |
| | |
----////////////////////----
Green ------|
/ *
/ * *
/ * * *
White ------/ * *
/ *
/
/
Gray -------|
I tried red-yellow and green-white, but all my motor does is make
noise and vibrate, no shaft rotation. Am I using the correct wires
or do I have a different problem?
Thanks
Kevin
Discussion Thread
Kevin
2003-05-14 16:18:03 UTC
What stepper wires to connect?
Fred Smith
2003-05-14 16:58:46 UTC
Re: What stepper wires to connect?
Fred Smith
2003-05-14 17:03:47 UTC
Re: What stepper wires to connect?
forumtvm
2003-05-14 17:16:20 UTC
Re: What stepper wires to connect?
Fred Smith
2003-05-14 17:36:54 UTC
Re: What stepper wires to connect?
Kevin
2003-05-14 18:21:25 UTC
Re: What stepper wires to connect?-next question
cadcamclub
2003-05-14 19:01:16 UTC
Re: What stepper wires to connect?-next question
Kevin
2003-05-14 19:17:08 UTC
Re: What stepper wires to connect?-next question
IMService
2003-05-15 07:26:09 UTC
Re: Re: What stepper wires to connect?-next question