CAD CAM EDM DRO - Yahoo Group Archive

Re: Re: What stepper wires to connect?-next question

Posted by IMService
on 2003-05-15 07:26:09 UTC
>Date: Thu, 15 May 2003 00:55:39 -0000
>From: "Kevin" <kevinh@...>
>Subject: Re: What stepper wires to connect?-next question

>Ok, I got my steppers to run only when I used the blue-red and green-
>gray. My next question, since I've never seen one of these run from
>any sort of driver, I was wondering if mine is running correct. Slow
>at the start, kind of choppy, then it speeds up if I jog over .25".
>Is this right?

Kevin,

There is a user support forum for DeskCNC at

http://www.imsrv.com/discus

Best Regards, Fred Smith- IMService

Listserve Special discounts and offers are at:
http://www.imsrv.com/hobby/grp.html

We are THE source for low cost Cad Cam

Discussion Thread

Kevin 2003-05-14 16:18:03 UTC What stepper wires to connect? Fred Smith 2003-05-14 16:58:46 UTC Re: What stepper wires to connect? Fred Smith 2003-05-14 17:03:47 UTC Re: What stepper wires to connect? forumtvm 2003-05-14 17:16:20 UTC Re: What stepper wires to connect? Fred Smith 2003-05-14 17:36:54 UTC Re: What stepper wires to connect? Kevin 2003-05-14 18:21:25 UTC Re: What stepper wires to connect?-next question cadcamclub 2003-05-14 19:01:16 UTC Re: What stepper wires to connect?-next question Kevin 2003-05-14 19:17:08 UTC Re: What stepper wires to connect?-next question IMService 2003-05-15 07:26:09 UTC Re: Re: What stepper wires to connect?-next question