Re: What stepper wires to connect?-next question

Ok, I got my steppers to run only when I used the blue-red and green-
gray. My next question, since I've never seen one of these run from
any sort of driver, I was wondering if mine is running correct. Slow
at the start, kind of choppy, then it speeds up if I jog over .25".
Is this right?

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Kevin" <kevinh@w...> wrote:
> I am in the process of hooking my 6 wire vextas up to my DeskCNC
> controller. I thought my motors were like some shown in the file
> section but they are not. Mine are PK268M-02A if that helps. Here
is
> a ascii copy of the diagram that came with them.
>
> Blue Yellow Red
> | | |
> | | |
> ----////////////////////----
>
>
> Green ------|
> / *
> / * *
> / * * *
> White ------/ * *
> / *
> /
> /
> Gray -------|
>
> I tried red-yellow and green-white, but all my motor does is make
> noise and vibrate, no shaft rotation. Am I using the correct wires
> or do I have a different problem?
>
> Thanks
> Kevin