Re: What stepper wires to connect?

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Kevin" <kevinh@w...> wrote:

> I am in the process of hooking my 6 wire vextas up to my DeskCNC
> controller. I thought my motors were like some shown in the file
> section but they are not.

Kevin, somebody posted this link earlier today:

http://www.mendonet.com/steppers/nema23.htm

At the very bottom, it shows the wires for a 4 wire and a 6 wire
stepper motor. Note that the colors for the 6 wire match some of
those on the 4 wire. I believe the 4 indicated are the ones to
connect on the 6 wire motors for use in a step and direction system.
Each pole would be conected to the AA or BB connections (on the
driver).

Also the DeskCNC controller is not supposed to be wired directly to
your motors. You need the controller/driver for that purpose.

Best Regards, Fred Smith- IMService

Listserve Special discounts and offers are at:
http://www.imsrv.com/hobby/grp.html

We are THE source for low cost Cad Cam