Re: http://www. cncmotion. com/

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "pcfw" <pcfw@y...> wrote:

> OK so the general conclusion is: it is not a "pure" lathe but more
> like a mill with an A-axis.
>
> Now if one is to try to use CAM system to generate the toolpath,

what

> is an easy way to ensure a seamless "joint" when one goes from the
> left end of the "flat earth" to the other right end, which in a
> real "round earth" are actually the same point/edge.

forgot to add that if one look down on this "flat earth" the surface
has depth which is absolutely vertical, but when one wraps the "flat
earth" round, what were the 2 extreme deep edges will only be nicely
joined along one "top?" edge, but will overlap below that.

Flat earth citizen who know not the earth is round