Re: Need xyz driver board kit...How do I interface the geckos drivers...
Posted by
wayne_j_hill
on 2003-06-05 21:17:20 UTC
I bought my RS-232 interface board kit from Camtronics.
http://www.seanet.com/~dmauch/
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Hector"
<hector_a_quintanilla@y...> wrote:
http://www.seanet.com/~dmauch/
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Hector"
<hector_a_quintanilla@y...> wrote:
> I need to know which gecko driver can drive te sanyo-DEnki HSeries,
> teh model I mentioned earlier. And I'm not an expert, I just
> starting so If I understand correct the geckos are single axis
> controllers, so I will need three, one for each axis x,y,and z. So
> with what kind of interface do I send signals to each separate
> driver? I want to send signals through the parallel port on my
> computer, from there to a interface that controls each axis.
> Regards..
> HEctor Quintanilla
Discussion Thread
Hector
2003-06-03 22:41:48 UTC
Need xyz driver board kit...Please advise
Robert Campbell
2003-06-04 07:18:52 UTC
Re: [CAD_CAM_EDM_DRO] Need xyz driver board kit...Please advise
turbulatordude
2003-06-04 07:51:42 UTC
Re: Need xyz driver board kit...Please advise
Hector
2003-06-05 18:30:22 UTC
Re: Need xyz driver board kit...Please advise--This is the motors I'm looking to
Hector
2003-06-05 18:35:54 UTC
Re: Need xyz driver board kit...How do I interface the geckos drivers...
cncnovice
2003-06-05 20:26:42 UTC
Re: Need xyz driver board kit...How do I interface the geckos drivers...
wayne_j_hill
2003-06-05 21:17:20 UTC
Re: Need xyz driver board kit...How do I interface the geckos drivers...
Robert Campbell
2003-06-06 05:34:10 UTC
Re: [CAD_CAM_EDM_DRO] Re: Need xyz driver board kit...How do I interface the geckos drivers...
Hector
2003-06-06 18:01:37 UTC
Re: Need xyz driver board kit...How do I interface the geckos drivers...
Robert Campbell
2003-06-06 18:41:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: Need xyz driver board kit...How do I interface the geckos drivers...