Re: Need xyz driver board kit...How do I interface the geckos drivers...

Hector,
Contact Robert Campbell on this group. He sells a first-class
breakout board that will make it easy to interface your PC to the
Geckos and limit switches - very reasonable in cost, too.

Good luck,
John Champlain




--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Hector"
<hector_a_quintanilla@y...> wrote:

> I need to know which gecko driver can drive te sanyo-DEnki H

Series,

> teh model I mentioned earlier. And I'm not an expert, I just
> starting so If I understand correct the geckos are single axis
> controllers, so I will need three, one for each axis x,y,and z. So
> with what kind of interface do I send signals to each separate
> driver? I want to send signals through the parallel port on my
> computer, from there to a interface that controls each axis.
> Regards..
> HEctor Quintanilla