Re: [CAD_CAM_EDM_DRO] Dan's announcement

Bill, any program that produces g-code output will work
with NIST's EMC, and should also work with DeskNCRT.
It will be a long time before DeskNCRT comes any where
close to EMC capabilities, but right now it says it reads
G-codes. There is a beta version of DeskNCRT at Carkens
website, you may want to foll with that.

Steve

----------
From: wanliker@...
To: CAD_CAM_EDM_DRO@onelist.com
Subject: Re: [CAD_CAM_EDM_DRO] Dan's announcement
Date: Sunday, March 26, 2000 8:16 AM

From: wanliker@...

Any recommendations on the CAM program that will work good with the EMC
capabilities?
Getting LINUX out of one box, and loading DOS 6.22 as the operating system.
bill

------------------------------------------------------------------------
DON'T HATE YOUR RATE!
Get a NextCard Visa, in 30 seconds! Get rates as low as
0.0% Intro or 9.9% Fixed APR and no hidden fees.
Apply NOW!
http://click.egroups.com/1/2120/2/_/423600/_/954087383/
------------------------------------------------------------------------

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to http://www.ktmarketing.com/faq.html
bill,
List Manager