CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Control Pendant/Panel layout for your comments

Posted by wanliker@a...
on 2003-10-16 07:44:44 UTC
In a message dated 10/16/2003 7:23:30 AM Pacific Standard Time,
jeff@... writes:
Would you change the layout?
I would move the E. Stop so it is not in the middle of the layout. I would
put it at an upper corner so in an Emergency, no visual input is needed, just
reach and hit it...........
Admittedly I am paranoid about the Estop button and circuit.................
bill


[Non-text portions of this message have been removed]

Discussion Thread

washcomp 2003-10-16 07:17:31 UTC Control Pendant/Panel layout for your comments wanliker@a... 2003-10-16 07:44:44 UTC Re: [CAD_CAM_EDM_DRO] Control Pendant/Panel layout for your comments washcomp 2003-10-16 16:05:32 UTC Re: Control Pendant/Panel layout for your comments wanliker@a... 2003-10-16 18:02:25 UTC Re: [CAD_CAM_EDM_DRO] Re: Control Pendant/Panel layout for your comments washcomp 2003-10-16 23:41:37 UTC Re: Control Pendant/Panel layout for your comments wanliker@a... 2003-10-16 23:47:00 UTC Re: [CAD_CAM_EDM_DRO] Re: Control Pendant/Panel layout for your comments ccq@x... 2003-10-17 04:37:48 UTC Reduction by 10 vavaroutsos 2003-10-17 09:11:10 UTC Re: Reduction by 10 ccq@x... 2003-10-17 11:05:17 UTC Re: [CAD_CAM_EDM_DRO] Re: Reduction by 10 Torsten 2003-10-17 12:13:01 UTC Re: Reduction by 10 ccq@x... 2003-10-17 14:26:03 UTC Re: [CAD_CAM_EDM_DRO] Re: Reduction by 10 caudlet 2003-10-17 16:39:07 UTC Re: Control Pendant/Panel layout for your comments Raymond Heckert 2003-10-17 20:00:02 UTC Re: [CAD_CAM_EDM_DRO] Re: Reduction by 10 washcomp 2003-10-17 20:00:38 UTC Re: Control Pendant/Panel layout for your comments