Re: Reduction by 10
Posted by
Torsten
on 2003-10-17 12:13:01 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, ccq@x wrote:
You have to decide on a belt type first they differentiate
in pitch and size a 30 tooth "L" type would have a larger
diameter then a "XL" type of the same tooth count.
A combination of a 15 tooth and a 30 tooth will give a 1:2 ratio,
10 tooth and a 30 tooth will give 1:3 ratio and so on.
The key to choosing the right Tooth count is in the smaller
Pulley a minimum tooth count is required for smooth operation
more teeth are better.
The larger Pulley is determined by the choosen ratio the dia.
of this Pulley will have to be looked up in the MFG specs.
Good Luck
> On timing belt setups, does a reduction of 10 requier a 5" wheeldriven by a 2"
> wheel, or would it be 5":2":1"?On Timing Belts the ratios are determined by the tooth count.
>
> Bill
You have to decide on a belt type first they differentiate
in pitch and size a 30 tooth "L" type would have a larger
diameter then a "XL" type of the same tooth count.
A combination of a 15 tooth and a 30 tooth will give a 1:2 ratio,
10 tooth and a 30 tooth will give 1:3 ratio and so on.
The key to choosing the right Tooth count is in the smaller
Pulley a minimum tooth count is required for smooth operation
more teeth are better.
The larger Pulley is determined by the choosen ratio the dia.
of this Pulley will have to be looked up in the MFG specs.
Good Luck
Discussion Thread
washcomp
2003-10-16 07:17:31 UTC
Control Pendant/Panel layout for your comments
wanliker@a...
2003-10-16 07:44:44 UTC
Re: [CAD_CAM_EDM_DRO] Control Pendant/Panel layout for your comments
washcomp
2003-10-16 16:05:32 UTC
Re: Control Pendant/Panel layout for your comments
wanliker@a...
2003-10-16 18:02:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: Control Pendant/Panel layout for your comments
washcomp
2003-10-16 23:41:37 UTC
Re: Control Pendant/Panel layout for your comments
wanliker@a...
2003-10-16 23:47:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Control Pendant/Panel layout for your comments
ccq@x...
2003-10-17 04:37:48 UTC
Reduction by 10
vavaroutsos
2003-10-17 09:11:10 UTC
Re: Reduction by 10
ccq@x...
2003-10-17 11:05:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: Reduction by 10
Torsten
2003-10-17 12:13:01 UTC
Re: Reduction by 10
ccq@x...
2003-10-17 14:26:03 UTC
Re: [CAD_CAM_EDM_DRO] Re: Reduction by 10
caudlet
2003-10-17 16:39:07 UTC
Re: Control Pendant/Panel layout for your comments
Raymond Heckert
2003-10-17 20:00:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: Reduction by 10
washcomp
2003-10-17 20:00:38 UTC
Re: Control Pendant/Panel layout for your comments