CAD CAM EDM DRO - Yahoo Group Archive

Re: Trak cnc 2 control replacement

Posted by seb fontana
on 2004-01-13 18:21:16 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Jon Elson <elson@p...> wrote:
>
>
> seb fontana wrote:
>
> > Jon
> > OK, we be making progress! I don't have to use both,
just the one thats recomended to work with what ever control/software
I end up getting..Probably the ones on motors as thats the talk seems
to be about...I can power it, so how do I check which wire does what?
The black and white wires I think [oh no!]are power cause where they
attached is sepparate from the other 4; the orange, red, green and
purple wires..So, how to check for sure? Seb.


> >
> OK, no doubt about it, that's an encoder for sure! No reason to
mess
> with it
> any further, except to figure out what wire does what. Since you
have the
> whole system, it might be possible to power up some part of it to
get power
> to the encoders, then you could figure out the power and signal
wires.
>
> But, I don't know what you are going to do with 2 encoders per
axis. I
> don't know of any PC software that can handle that!
>
> Jon

Discussion Thread

seb fontana 2004-01-10 17:19:46 UTC Trak cnc 2 control replacement Jon Elson 2004-01-10 20:09:04 UTC Re: [CAD_CAM_EDM_DRO] Trak cnc 2 control replacement seb fontana 2004-01-10 21:47:08 UTC Re: Trak cnc 2 control replacement jcc3inc 2004-01-11 06:55:28 UTC Re: Trak cnc 2 control replacement Jon Elson 2004-01-11 14:24:17 UTC Re: [CAD_CAM_EDM_DRO] Re: Trak cnc 2 control replacement seb fontana 2004-01-12 17:33:30 UTC Re: Trak cnc 2 control replacement Jon Elson 2004-01-12 22:11:35 UTC Re: [CAD_CAM_EDM_DRO] Re: Trak cnc 2 control replacement seb fontana 2004-01-13 18:21:16 UTC Re: Trak cnc 2 control replacement Harvey White 2004-01-13 21:21:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Trak cnc 2 control replacement Jon Elson 2004-01-13 22:38:50 UTC Re: [CAD_CAM_EDM_DRO] Re: Trak cnc 2 control replacement doug98105 2004-01-14 05:39:46 UTC Re: Trak cnc 2 control replacement seb fontana 2004-01-14 22:07:43 UTC Re: Trak cnc 2 control replacement