Re: [CAD_CAM_EDM_DRO] Help with 8-wire stepper configuration
Posted by
Amaury Jacquot
on 2004-01-23 13:26:54 UTC
Brian wrote:
between the 8 cables (only 16 combinations possible)
you'll find the coils easily
> Hi, sometimes you can remove the back cover, being careful to keep the rotormuch simpler yet, get yourself a basic controller and check resitstance
> in the housing, that will allow you another 1/2 inch to work with the wires.
> solder and heatshrink.. If you are not adept to soldering, if your close to
> NH i would say ship em up i will try to reconnect. maybe someone near does
> electronic work(ham radio) probably do it for coffee!
> cul brian f.
between the 8 cables (only 16 combinations possible)
you'll find the coils easily
Discussion Thread
Statman Designs, LLC
2004-01-23 11:30:49 UTC
Help with 8-wire stepper configuration
Brian
2004-01-23 11:46:25 UTC
Re: [CAD_CAM_EDM_DRO] Help with 8-wire stepper configuration
Statman Designs, LLC
2004-01-23 12:01:33 UTC
Re: [CAD_CAM_EDM_DRO] Help with 8-wire stepper configuration
Alan Marconett KM6VV
2004-01-23 12:14:34 UTC
Re: [CAD_CAM_EDM_DRO] Help with 8-wire stepper configuration
Statman Designs, LLC
2004-01-23 13:04:53 UTC
Re: [CAD_CAM_EDM_DRO] Help with 8-wire stepper configuration
Amaury Jacquot
2004-01-23 13:26:54 UTC
Re: [CAD_CAM_EDM_DRO] Help with 8-wire stepper configuration
rockinwood_2000
2004-01-23 13:27:28 UTC
Re: Help with 8-wire stepper configuration
Ed Gilbert
2004-01-23 13:27:58 UTC
RE: [CAD_CAM_EDM_DRO] Help with 8-wire stepper configuration
Alan Marconett KM6VV
2004-01-23 15:38:35 UTC
Re: [CAD_CAM_EDM_DRO] Help with 8-wire stepper configuration
Ed Gilbert
2004-01-23 16:55:00 UTC
RE: [CAD_CAM_EDM_DRO] Help with 8-wire stepper configuration
Statman Designs, LLC
2004-01-23 18:46:14 UTC
Re: [CAD_CAM_EDM_DRO] Help with 8-wire stepper configuration