Re: [CAD_CAM_EDM_DRO] 28v power transformer

>
> I Can't fine it.
>
> ----- Original Message -----
> From: "Alan Marconett KM6VV" <KM6VV@...>
> To: <CAD_CAM_EDM_DRO@yahoogroups.com>
> Sent: Wednesday, April 21, 2004 11:52 AM
> Subject: Re: [CAD_CAM_EDM_DRO] 28v power transformer
>
> > Hi Bob,
> >
> > You probably have two primaries. Wire them in parallel for 120v. Check
> > out the schematic in the files section under Driver/PS.
> >
> > Alan KM6VV
> >
> > stcnc2000 wrote:
> > >
> > > Hi,
> > > I'm building a power supply kit. I have a question on the primary
> > > side of the transformer, which has four wires. How do i wire this to
> > > 110 vac?
> > > thanks
> > > Bob
> > >
> > >