Gecko Faults
Posted by
kadeshan
on 2004-11-05 05:42:54 UTC
Here is a little background, just got an exact jr bare frame, and was
going to add my own motors/controls. Here is the mill
http://www.ameritechcnc.com/exact%20jr%20series.htm I asked them
what servos they use, and they said 16 ft lbs cleveland servos.
Direct drive. I got some off of ebay. I bought these motors
thinking they would be sufficient
http://cgi.ebay.com/ws/eBayISAPI.dll?
ViewItem&category=42895&item=3849879999&rd=1 . I got everything
hooked up, I have the accel/velocity turned way down. They fault
almost immediately. Is there something I am doing wrong, or these
motors just not up the the job at hand? Thanks
going to add my own motors/controls. Here is the mill
http://www.ameritechcnc.com/exact%20jr%20series.htm I asked them
what servos they use, and they said 16 ft lbs cleveland servos.
Direct drive. I got some off of ebay. I bought these motors
thinking they would be sufficient
http://cgi.ebay.com/ws/eBayISAPI.dll?
ViewItem&category=42895&item=3849879999&rd=1 . I got everything
hooked up, I have the accel/velocity turned way down. They fault
almost immediately. Is there something I am doing wrong, or these
motors just not up the the job at hand? Thanks
Discussion Thread
kadeshan
2004-11-05 05:42:54 UTC
Gecko Faults
R Rogers
2004-11-05 05:58:05 UTC
Re: [CAD_CAM_EDM_DRO] Gecko Faults
Bloy2004
2004-11-05 05:58:57 UTC
Re: Gecko Faults
kadeshan
2004-11-05 06:31:31 UTC
Re: Gecko Faults
Bloy2004
2004-11-05 06:47:13 UTC
Re: Gecko Faults
danialsan2
2004-11-05 08:53:41 UTC
Re: Gecko Faults
Jon Elson
2004-11-05 09:01:10 UTC
Re: [CAD_CAM_EDM_DRO] Gecko Faults
Bloy2004
2004-11-05 09:05:37 UTC
Re: Gecko Faults
kadeshan
2004-11-05 10:45:38 UTC
Re: Gecko Faults
R Rogers
2004-11-05 10:53:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults
R Rogers
2004-11-05 11:03:43 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults
kadeshan
2004-11-05 12:14:27 UTC
Re: Gecko Faults
R Rogers
2004-11-05 16:26:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults
Jon Elson
2004-11-05 21:27:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults
Jon Elson
2004-11-05 21:28:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults