Re: Gecko Faults
Posted by
Bloy2004
on 2004-11-05 09:05:37 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "danialsan2"
<danialsan@a...> wrote:
directly, they would have the torque to respond to the commands
without drive reduction (and function with higher cpr encoders). But
with the smaller motors, they will be required to opperate at higher
rpms (thus more torque) and not immediately fall too far behind in
commanded position thus faulting out.
Bloy
<danialsan@a...> wrote:
> Hi all,rated
> I'm new to this CNC building and just now starting my own machine.
> Is it a typo where you said they used 16 ft lbs servos? I thought
> this figures out to 3072 oz-in and the ones you purchased were
> at 360 oz-in or 22.5 lbs-in. There seems to a mix up in ft-lbs andin-
> lbs. Then again I am new to thisYou're right (barring a typo). With those big honkers on the screws
>
> Dan
directly, they would have the torque to respond to the commands
without drive reduction (and function with higher cpr encoders). But
with the smaller motors, they will be required to opperate at higher
rpms (thus more torque) and not immediately fall too far behind in
commanded position thus faulting out.
Bloy
Discussion Thread
kadeshan
2004-11-05 05:42:54 UTC
Gecko Faults
R Rogers
2004-11-05 05:58:05 UTC
Re: [CAD_CAM_EDM_DRO] Gecko Faults
Bloy2004
2004-11-05 05:58:57 UTC
Re: Gecko Faults
kadeshan
2004-11-05 06:31:31 UTC
Re: Gecko Faults
Bloy2004
2004-11-05 06:47:13 UTC
Re: Gecko Faults
danialsan2
2004-11-05 08:53:41 UTC
Re: Gecko Faults
Jon Elson
2004-11-05 09:01:10 UTC
Re: [CAD_CAM_EDM_DRO] Gecko Faults
Bloy2004
2004-11-05 09:05:37 UTC
Re: Gecko Faults
kadeshan
2004-11-05 10:45:38 UTC
Re: Gecko Faults
R Rogers
2004-11-05 10:53:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults
R Rogers
2004-11-05 11:03:43 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults
kadeshan
2004-11-05 12:14:27 UTC
Re: Gecko Faults
R Rogers
2004-11-05 16:26:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults
Jon Elson
2004-11-05 21:27:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults
Jon Elson
2004-11-05 21:28:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults